Installing A 3.5 Inch Hard-Drive Blank; Removing A 2.5 Inch Hard Drive From A 3.5 Inch Hard-Drive Adapter - Dell PowerEdge T420 Owner's Manual

Figure 22. Removing and Installing a 3.5 Inch Hard-Drive Blank
1. hard-drive blank
2. release button

Installing A 3.5 Inch Hard-Drive Blank

1. If installed, remove the front bezel.
2. Insert the hard-drive blank into the hard-drive slot until the release button clicks into place.
3. If applicable, install the front bezel.

Removing A 2.5 Inch Hard Drive From A 3.5 Inch Hard-Drive Adapter

NOTE: A 2.5 inch hard drive is installed into a 3.5 inch hard-drive adapter, which is then installed in the 3.5 inch
hard-drive carrier.
1. Remove the two screws from the side of the 3.5 inch hard-drive adapter.
2. Remove the hard-drive away from the hard-drive adapter.
Figure 23. Removing and Installing a 2.5 Inch Hard Drive Into a 3.5 Inch Hard-Drive Adapter
57