How To Handle Basic Operations - JVC TM-H1950CG Instructions Manual

HOW TO HANDLE BASIC
OPERATIONS
BASIC OPERATION
1. Press the main power switch to turn on the power.
2. Press the POWER switch to turn on the power.
POWER
3. Press the INPUT SELECT buttons to choose input.
A B C SLOT D
INPUT SELECT
4. Press the VOLUME/SELECT buttons to adjust the
speaker volume.
VOLUME/SELECT
PICTURE ADJUSTMENT
1. Press select buttons corresponding to the item
you want to adjust.
CHROMA CONTRAST
PHASE BRIGHT
2. Adjust with the VOLUME/SELECT buttons.
VOLUME/SELECT
10
ON : Power turns ON. (Power indicator: lit)
Green : The main power is ON, and the monitor's
power is ON (in the normal operation mode).
OFF : Power turns OFF. (Power indicator: unlit)
Orange : The main power is ON, but the monitor's
power is OFF (in the standby mode)
Unlit : The main power is OFF.
Select video/audio signals input to terminals on the rear
panel. The selected button lights in green.
INPUT
Terminals on the rear panel
SELECT
Video signal input
buttons
1
Input A
VIDEO A terminal
(VIDEO)
2
Input B VIDEO B terminal
(VIDEO/Y/C)
VIDEO B (Y/C) terminal
3
Input C
Refer to page 7 for details about the input terminals
4 on each card and the INPUT SELECT button.
Input D
Note: The Y/C (S-video) terminal has priority.
Press this button to display the speaker volume level on the
screen.
+ : The speaker volume is increased. (00
– : The speaker volume is decreased. (50
* Screen indication will disappear about 10 seconds after operating.
* The on-screen display goes off when you press MENU button.
The item you select is displayed on the screen.
1
Chorma control : Press the CHROMA/PHASE button once.
2
Phase control : Press the CHROMA/PHASE button twice.
3
Contrast control : Press the CONTRAST/BRIGHT button once.
4
Brightness control : Press the CONTRAST/BRIGHT button twice.
* Pressing the CHROMA/PHASE button and CONTRAST/BRIGHT button
alternately while the item is shown on screen restores the previous status.
When no item is shown on screen, CHROMA and CONTRAST have priority.
VOLUME/SELECT button
Items
–
CHROMA
lighter
(Chroma)
PHASE
reddish
(Phase)
CONTRAST
lower
(Contrast)
BRIGHT
darker
(Brightness)
* Screen indication will disappear about 10 seconds after operating.
* The on-screen display goes off when you press MENU button.
About the STATUS indication
● With the COLOR SYSTEM setting set
Audio signal input
AUDIO A terminal
AUDIO B terminal
[ 50)
[ 00)
● Phase control is effective only in the
+
● Chroma control is not effective when
deeper
greenish ● When CHROMA is adjusted to "–40,"
● "NO EFFECT" is displayed (for about
higher
brighter
● To change the display position on
STATUS indication
(PAL or NTSC)
PAL
to AUTO mode, when you turn on the
power or select inputs, the color
system indication appears for about
3 seconds on the screen while PAL or
NTSC signals are being detected.
It does not appear when receiving a
B/W signal or when no signal is input.
Refer to page 11 for more information
about COLOR SYSTEM setting and
page 13 for more information about
STATUS indication setting.
00 ~ 50
VOLUME : 20
+
–
UPPER
–40 ~ +40
PHASE : 00
PHASE : 00
+
–
Notes:
LOWER
NTSC color system mode.
receiving RGB and B/W or when no
signal is input. (Except when a
component signal is input.)
the picture becomes less colorful.
3 seconds) when your selected
function has no effect.
screen, set UPPER or LOWER with
ADJ. BAR POSI.