Figure 4-5: Secureeasysetup Screen; Figure 4-6: Secureeasysetup Logo; Figure 4-7: Secureeasysetup Logo Location - Linksys WPC54GS User Manual

Wireless-G Notebook Adapter with SpeedBooster
Setting Up the Adapter with SecureEasySetup
With SecureEasySetup, setting up the Adapter is as simple as pushing a couple of buttons. Before you press any
buttons, though, you should locate the SecureEasySetup button on the device you're connecting the Adapter to,
such as a wireless router or access point.
1. Starting from the Available Wireless Network screen, click the SecureEasySetup button on the right hand
side.
2. You will be asked to locate the SecureEasySetup button on the device with which the Adapter will be
communicating. If you are not sure where to find this button, click Where can I find the button?.
This will walk you through a couple of screens to help you find the button, which is usually located on the
front of the wireless router or access point.
3. Press the Router or Access Point's SecureEasySetup button on its front panel. After approximately two to ten
seconds, the button will turn white and begin to blink.
If your other SecureEasySetup device is not yet installed, Click the Next button to continue and finish the
Router's installation. Then, to install the other device, follow the instructions provided with that device for
SecureEasySetup.
If your other SecureEasySetup device is already installed, press the SecureEasySetup button on that
device within two minutes. (The button on that device may be on the device's software that you will have to
click on-screen.) Click the Next button to continue and finish the Router's installation.
To add other SecureEasySetup devices to your network, follow the instructions provided with each device.
NOTE: You can only add one SecureEasySetup device at a time.
Chapter 4: Setting up and Connecting the Wireless-G Notebook Adapter
Setting up the Adapter
Figure 4-5: Locate the Button

Figure 4-6: SecureEasySetup Logo

Figure 4-7: SecureEasySetup Logo Location

9