Operation; Maintenance - Drill Master 69487 Owner's Manual

Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Make sure that the power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
Page 10 For technical questions, please call 1-800-444-3353.
3. Remove the Waxing/Polishing Bonnets from the
Pad when the Waxer/Polisher is not in use. This will
allow the Pad to dry and retain its original shape.
4. To prolong Pad life and shape, store
the Polisher with the Pad face up.
5. The Waxing/Polishing Bonnets may be
machine washed in cold water with detergent.
Then machine dry at medium heat.
6. WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Item 69487