Options - Harman P61A Freestanding Pellet Stove Installation & Operating Manual

side heat shields
Side heat shields are available to reduce the clearance to
combustible materials.
Part #1-00-08631
hopper extension -Part #1-00-08636
The hopper extension allows you to put more pellet fuel
in the hopper which extends the burn time on one load of
pellets. The hopper extension adds 70 pounds to the existing
hopper capacity, allowing you to load 140 pounds of pellets
at one time. The extension seals to the unit hopper with three
latches. Some models will require a knockout be removed
from the unit hopper prior to installing the extension.
3-90-05822R29_10/13

options

On the rear of the stove hopper there is a
hole to fasten the hopper extension into place.
On some units, this hole will need to be
opened. You will notice a small uncut area on
rear of the knockout. Push downward with a
screwdriver or like tool until the knockout is
rotated as far back to the inside of the hopper
as possible. This will allow the swell latch of the
hopper extension to fully expand to the bottom
side of the hole for a proper seal.
direct vent wall Passthrough kit
You may choose to use the optional Direct Vent Wall
Passthrough Kit (part #1-00-677177) which incorporates
venting passthrough and outside air into one component.
decorative slate options
The decorative slate tiles measure 11.938" x 5.938". The
tile/slate frame is not necessary to hold the tile in place on
the stove. There are 4 decorative slate choices. See dealer
for samples.
The Brushed Stainless deer cutout, pictured below, is another
option available. This cutout reveals the color of the stove
through the cut out shapes.
frame
tile/slate
11.938"
P61A Pellet Stove 30