Configuring Wpa Security With Microsoft Security - Intermec CK31 User Manual

CK31 Handheld Computer User's Manual
3 Open Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security
> Profile.
5 For Association, choose WPA or WPA2 and press Enter.
6 For 8021x, choose None and press Enter.
7 For Pre-Shared Key, enter the pre-shared key or the
passphrase.
The pre-shared key must be a value of 32 hex pairs preceded
by 0x for a total of 66 characters. The value must match the
key value on the access point. The passphrase must be from 8
to 63 characters. After you enter a passphrase, the CK31
internally converts it to a pre-shared key.
This value must match the passphrase on the authenticator.
8 Exit Intermec Settings.

Configuring WPA Security With Microsoft Security

Use these procedures to set WPA-802.1x and WPA-PSK
security on your CK31 with Microsoft security.
To enable WPA-802.1x with Microsoft security
1 Make sure you have configured the communications and
radio parameters on your CK31.
2 Open Intermec Settings.
3 Choose Communications > 802.11 Radio > Microsoft
Security.
4 For Infrastructure Mode, choose Infrastructure.
5 For Network Authentication, choose WPA. Data
Encryption automatically defaults to TKIP.
6 For 802.1x Authentication, choose either TLS or PEAP.
If you choose TLS:
a Select Properties and tap the Run App button. The Auth.
Settings dialog box appears.
Chapter 2 — Configuring the CK31
65