Selecting A Location For The Tv; Connecting Your Tv - Hitachi 50HDA39 Operating Manual

Hitachi plasma television operating guide for 50hda39
Hide thumbs Also See for 50HDA39:
Table of Contents

Advertisement

Exploring your new TV
Back of TV
AUDIO/VIDEO OUT
(Page 14)
IR OUT (Page 15)
Left back panel

Selecting a location for the TV

• Place the TV on the floor or on a sturdy platform in
a location where light does not directly hit the
screen.
• Place the TV far enough from the walls to allow
proper ventilation. Inadequate ventilation may
cause overheating, which may damage the TV.

Connecting your TV

If you haven't connected electronic equipment before, or
you have been frustrated in the past, you may wish to read
this section. (Cables are not supplied.)
• A coaxial cable is the standard cable that comes in from
your antenna or cable converter box. Coaxial cables use
"F" connectors.
• Standard A/V (audio/video) cables are usually color
coded according to use: yellow for video and red and
white for audio. The red audio cable is for the stereo
right channel, and the white audio cable is for the stereo
left (or mono) channel. If you look at the rear panel of
the TV, you will see that the terminals are color coded in
the same manner as the cables.
• S-video cables provide better picture performance than
standard video cables. S-video cables can only be used
with S-video compatible components.
• Component video cables provide better picture
performance than S-video cables. Component video
cables can only be used with component video
compatible components.
3X80801A_En_p02-09
7
OPTICAL AUDIO OUT
Cable holder
(Page 14)
COAXIAL
VIDEO-2 IN
AUDIO OUT
(Page 9)
(Page 14)
PC IN
HDMI-1 IN
(Page 16)
(Page 13)
COMPONENT2 IN
COMPONENT1 IN
(Page 10)
VIDEO-1 IN
(Page 9)
HDMI-2 IN
(Page 13)
ANTENNA
Coaxial Cable
Component video
AUDIO
Cables
VIDEO
Cable
IR blaster
S-Video
Cable
• HDMI (High Definition Multimedia Interface) cable
is for use with video equipment that has HDMI
output (see page 13.)
• IR blaster cable is for use with video device with
IR (infrared) remote control.
• Optical/Coaxial cable is for use with AV amplifier
with built-in digital surround (Dolby Digital or
PCM.)
NOTE: DO NOT CONNECT A PC
USING ONE OF THE HDMI INPUTS.
ALWAYS use the VGA port provided to connect a PC.
7/11/06, 8:07 PM
(Page 10)
ANT (Page 8)
AC INLET
(Page 16)
Right back panel
Cables
HDMI
Cable
Cable
Optical
Cable
Coaxial
Cable
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

50hda39om

Table of Contents