Travel Check Of The Head/Carriage Unit And Initial Setup Mode; Travel Check Of The Head/Carriage Unit And Initial Setup Mode (Function Code 63) - Brother MFC5490CN Service Manual

9.4.17 Travel Check of the Head/Carriage Unit and Initial Setup Mode

(Function code 63)
Function
This procedure moves the head/carriage unit to the center of its travel (Function code 63 + *).
It can also enable or disable the initial setup mode when the power is applied at the next time
(Function code 63 + 1 or Function code 63 +3).
Operating Procedure
(1) Press the 6 and 3 keys in this order in the initial stage of the maintenance mode.
The "SELECT 63?" appears on the LCD.
(2) Press the Black Start (Mono Start) key.
The "START 63?" appears on the LCD.
(3) To make the head/carriage unit travel to the center of its travel, press the * key.
After completion of head replacement or adjustment jobs, press the Stop/Exit key. The
head/carriage unit returns to the home position and then locks itself.
(4) To enable or disable the initial setup mode when the power is applied at the next time,
perform steps (1) and (2) again and then press the 1 or 3 key, respectively.
If you enable the initial setup mode, wait until the "INIT" appears on the LCD and the
head/carriage unit becomes locked. When the "HEAD LOCKED" appears, turn the power
off.
NOTE: Enabling the initial setup mode resets all counts which can be displayed with
Function code 80 (described in
code 80)
If you disable the initial setup mode, the machine displays the "NOT INIT" on the LCD
and returns to the initial stage of the maintenance mode.
(User-accessible)").
Section 9.4.25 "Display of the Equipment's Log (Function
9-33
Confidential