VLAN ID — Specifies the VLAN ID
l
Port/Trunk Toggle Buttons — Allows you to select ports or trunks that are attached to a neighboring multicast router/switch by toggling the value of
l
the port/trunk button:
'S' — Statically attaches a port or trunk to a multicast router/switch
¡
'D' — Indicates that a port or trunk has been dynamically attached to a multicast router/switch
¡
'BLANK' — Indicates that the port or trunk is not attached to a multicast router/switch
¡
To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.
CLI Commands
The following table summarizes the equivalent CLI commands for items in the Multicast Support/Multicast Router Port Settings page.
Command
ip igmp snooping vlan vlan-id mrouter interface
show ip igmp snooping mrouter [vlan vlan-id]
Example
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/5
Console(config)#exit
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Port Type
Usage
Statically configures a multicast router port
Displays information on statically configured and dynamically learned multicast router ports