USB/VGA board
Description
USB/VGA board (includes cable)
Before removing the USB/VGA board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Switch cover (see
e.
Display assembly (see
f.
Top cover (see
g.
Fan (see
h.
Heat sink (see
i.
Modem module (see
j.
System board (see
Remove the USB/VGA board:
1.
Position the computer right-side up, with the front toward you.
2.
Remove the Torx T8M2.5×6.0 screw (1) that secures the USB board to the base enclosure.
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Display assembly on page
Top cover on page
Fan on page
74)
Heat sink on page
Modem module on page
System board on page
47).
54)
49)
65)
72)
82)
88)
76)
92)
97)
Component replacement procedures 101
Spare part number
595782-001