Char-Broil T-22D Product Manual page 8

WARNING
Turn controls and gas source or tank OFF when not
in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Main Burner Match-Lighting
▲
Do not lean over grill while lighting.
1. Turn OFF all gas burner control valves.
2. Turn ON gas at LP cylinder.
3. Open lid during lighting.
4. Place match into match holder (hanging from side of cart).
Light match, place into lighting hole on right or left side of
firebox.
5. Push in and turn right or left knob to
sure burner lights and stays lit.
6. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes, and repeat the lighting
procedure.
7. Light other burner by pushing knob in and turning to
position.
8
Burner Flame Check
•Remove cooking grates and troughs. Light burners, rotate
knobs from
on sideburner, also. Always check flame prior to each use. If
only low flame is seen refer to "Sudden drop or low flame" in
the Troubleshooting Section.
Turning Grill Off
• Turn all knobs to
Ignitor Check
• Turn gas off at LP cylinder. Press and hold electronic ignitor
Valve Check
• Important: Make sure gas is off at LP cylinder before
position. Be
Hose Check
• Before each use, check to see if hoses are cut or worn.
General Grill Cleaning
• Do not mistake brown or black accumulation of grease and
• Plastic parts: Wash with warm soapy water and wipe dry.
• Porcelain surfaces: Because of glass-like composition, most
• Painted surfaces: Wash with mild detergent or nonabrasive
• Stainless steel surfaces: To maintain your grill's high quality
• Cooking surfaces: If a bristle brush is used to clean any of
to . You should see a smaller flame in
position than seen on
OFF position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
button. "Click" should be heard and spark seen each time
between each collector box or burner and electrode. See
"Troubleshooting" if no click or spark.
checking valves. Knobs lock in OFF position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn back to
OFF position. Valves should turn smoothly.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
smoke for paint. Interiors of gas grills are not painted at the
factory (and should never be painted). Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom. Rinse and allow to completely
air dry. Do not apply a caustic grill/oven cleaner to painted
surfaces.
▲
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use nonabrasive scouring powder
for stubborn stains.
cleaner and warm soapy water. Wipe dry with a soft
nonabrasive cloth.
appearance, wash with mild detergent and warm soapy water
and wipe dry with a soft cloth after each use. Baked-on grease
deposits may require the use of an abrasive plastic cleaning
pad. Use only in direction of brushed finish to avoid damage.
Do not use abrasive pad on areas with graphics.
the grill cooking surfaces, ensure no loose bristles remain on
cooking surfaces prior to grilling. It is not recommended to
clean cooking surfaces while grill is hot.
. Perform burner flame check