Char-Broil T-22D Product Manual page 18

Inside of cart, insert rear tabs (w/o holes) of tank heat shield into slots on the bottom of upper back panel, shown A.
9
Attach front tabs (w/ holes) of tank heat shield under front brace using two #8x3/8" self-tapping screws, shown B.
Upper back panel
A
Insert tabs into slots
Left side panel
Connect each of the wires from main burner electrodes into the back of Electronic Ignition Module. Total (2)
10
connections. Connect the two wires [(a) and (b)] from switch wiring harness into the back of the Electronic
Ignition Module. Total (2)connections, shown A. Unscrew the cap and nut from electronic ignition module. Attach
electronic ignition module to the cart left side panel with the nut, shown B. Insert AA battery into electronic
ignition module, negative (—) end first. Replace the cap, shown C.
A
NOTE: Switch terminals are larger than electrode terminals
and should only be installed in location shown as (a), (b).
18
Right side panel
Tank heat shield
Note: Some parts omitted for
clarity of illustration
(a)
1
2
(b)
#8x3/8" self-tapping
Leave wires outside when attaching
tank heat shield to front brace.
B
Nut
C
Cap
-
+
AA Battery
B
Front brace
screw
Electronic
ignition module