Maintenance And Service - DeLonghi ELECTRIC OIL FILLED RADIATOR Instructions Manual

THE TIMER
Period of
operation
See figure below:
IMPORTANT: the timer consists of 96 teeth, each representing a 15-minute period. The
appliance can be programmed to come on and go off at set times. With the timer, the
appliance is programmed to within 15 minute intervals and you can programme up to
48 cycles (each cycle consists of a coming on and a going off time) during a 24 hour
period). The teeth can be pushed or pulled with your fingers. When a tooth is pushed
towards the centre of the dial, the radiator remains in operation for those 15 minutes.
If the tooth is pulled out, the radiator is off during that period.
Using the timer
A) Plug into the mains socket.
B) Turn the dial clockwise to set the current time (see SETTING THE CLOCK).
C) Push the teeth corresponding to the period you do not want the radiator to operate
towards the outside. For example, the radiator in the figure will be on from 2.00 to
5.00.
D) Turn the power selector to the required position (1, 2 or 3).
E) Once the teeth have been set for the desired periods of heating, the radiator will
come on and go off as set.
F) While the radiator remains plugged into the socket, the timer retains the correct time.
CUTTING OUT THE TIMER (models with selector only)
To cut out the timer, place the selector in the I position (see figure).
To go back to programmed operation, place the selector in the
NB: when the selector is in the 0 position, the appliance is off. In the I and 0 positions,
the timer is still set to the current time.
Safety device
A safety device shuts the radiator down in the case of overheating. To start the radiator
up again, call the nearest service centre.
MODELS WITH "Tilt-switch"
Some models are fitted with a tilt-switch turns the appliance off if it should fall over. To
restart the appliance, simply place it upright again.

6. MAINTENANCE AND SERVICE

Before performing any operations on the appliance, always unplug from the mains socket
4
Tooth
Pointer
Selector (some models only)
Manual mode
Programme mode
Appliance off
position.