Set-Up And System Configuration - Crown DCi 8|600N Operation Manual

Set-up and System Configuration

Wire Input Connectors
Crown recommends using pre-built or professionally wired balanced cables (two-conductor plus
shield). Balanced wiring provides better rejection of unwanted noise and hum; however, unbalanced
line may also be used. For more information, refer to the Crown Amplifier Application Guide, available
online at www.crownaudio.com.
Use 6-pin plug-in cable ends at the amp input connectors. A male connector is supplied for each input
of your model of amplifier. Additional connectors are available from Crown (P/N 5024623).
Figure 3 shows connector pin assignments for balanced wiring and Figure 4 shows connector pin
assignments for unbalanced wiring. Note that for bridged operation, only the connectors for odd-
numbered channels (1,3,5,7) for each bridged pair need be wired.
For BLU Link audio connection, standard Category 5e cabling can be used. To increase fault tolerance
of the BLU Link audio ring, the input and the output should be connected to adjacent BLU Link nodes.
There is a maximum limit of 60 BLU Link nodes for each audio ring.
Wire Output Connectors
Crown has designed an output cover that does not need to be removed
to connect the output wiring.
Crown recommends using the included spade connectors and two- or
four-conductor, heavy gauge speaker wire. You may use terminal forks
up to 10 AWG or bare wire for your output connectors (see Figure 5).
For best results, Crown recommends Panduit part #PV10-10LF-L or
equivalent terminal fork. For bare wire, it is highly recommended that
output wiring is tinned. To reduce strain on input and output wiring,
Crown recommends the use of horizontal lacer bars. For best results,
Crown recommends Middle Atlantic part# LBP-4R90 or equivalent
horizontal lacer bar.
For low-impedance loads, select the appropriate size of wire based on
the distance from amplifier to speaker.
Distance Wire Size
Up to 25 ft. (7.6m) 16 AWG
26-40 ft. (7.9-12.2m) 14 AWG
41-60 ft. (12.5-18.3m) 12 AWG
> 60 ft (18.3m) 10 AWG
CAUTION: Never use shielded cable for output wiring.
CAUTION: Never connect the speaker return to the chassis of the amplifier, or damage to the amplifier may result.
NOTE: Custom wiring should only be performed by qualified personnel. Class 2 output wiring is required.
page 8
DriveCore Install Network Series Power Amplifiers
Figure 3
Figure 4
Figure 5
Operation Manual