Crown DCi 8|600N Operation Manual page 22

DriveCore Install Network Series Power Amplifiers
Set-up and System Configuration
Bridge Mode (16, 8, or 4 Ohm) Output Operation
Typical input and output wiring, along with software settings
are shown in Figure 13.
INPUT WIRING: If using analog inputs, it is only necessary
to wire the odd number inputs. If using the BLU Link input,
it is important to understand that BLU Link is a digital audio
bus and cannot be routed through a network switch or router.
To increase fault protection, use both the input and output
BLU Link wiring connection. For BLU Link routing, refer to
page 25.
OUTPUTS: Connect the speaker across the positive terminals
of each channel pair. Do not use the negative terminals of
the channel pair when the pair is being operated in Bridge-
Mono mode.
Figure 13 System Wiring Bridge Mode
Figure 13 The bridge mono checkbox must be checked for proper operation
Always route the input and output wires in separate bundles.
Operation Manual
page 22