Crown DCi 8|600N Operation Manual page 15

DriveCore Install Network Series Power Amplifiers
the value.
A blank field or '-' implies the value is null
Device Name
The user-definable Device Name is displayed, as reported by the discovered device
• May be edited inline if you want to change the Device Name.
• May not be edited for discovered PCs running an instance of HiQnet software.
Devices not discoverable at the IP or HiQnet level
A device which is not discoverable at the IP level (invalid IP address etc) or HiQnet address level (HiQnet address conflict etc) will not be able to report its Device Name. In
this instance, the Device Name field will display a '?' to indicate that the field may exist but that the software does not have enough discoverability of the device to determine
the value
A blank field or '-' implies the value is null
Once edits have been made, it is critical to click the "Apply Current Edits" or "Apply and Exit" buttons.
Container : Position
The Container and Position Venue Data is displayed (separated by a colon), as reported by the discovered device. The field is left blank for discovered PCs running an
instance of HiQnet software.
• System Architect
• Performance Manager
• London Architect
The Container / Position Venue Data may not be edited inline.
A selected device may have its Venue Data cleared (including all Building, Floor and Room Venue data) by pressing the Clear Container button. This action takes place on
applying current edits only and can be undone with the Undo Current Edits button
Devices not discoverable at the IP or HiQnet level
A device which is not discoverable at the IP level (invalid IP address etc) or HiQnet address level (HiQnet address conflict etc) will not be able to report its Device Name. In
this instance, the Device Name field will display a '?' to indicate that the field may exist but that the software does not have enough discoverability of the device to determine
the value
A blank field or '-' implies the value is null
Locate
Clicking in the Locate column for a device will put the corresponding device on the network into a Locate state, and the Locate icon will be displayed.
• Clicking an active Locate icon will disable the Locate state for the device
• Disabling the Locate state from the device will clear the icon
• Devices may be put into Locate state independently from selection so that more than one device can be located at any one time
Operation Manual page 15