Pppoe - D-Link DAP-1160 User Manual

Section 2 - Configuration
Choose PPPoE (Point-to-Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username
and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The
software is no longer needed and will not work through the DAP-1160.
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then
retype the password in the next box.
Service Name:
Enter the ISP Service Name (optional).
S e l e c t A l w a y s o n , O n d e m a n d , o r
Reconnection
Type:
Manual.
Maximum Idle
Enter a maximum idle time during which
time:
the Internet connection is maintained
during inactivity.
MTU Size:
Y o u m a y n e e d t o c h a n g e t h e M T U
(Maximum Transmission Unit) for optimal
performance with your specific ISP. The
default MTU size is 1492.
Attain DNS
Select this option if you want the DAP-1160
Automatically:
to get the DNS (Domain Name System)
server IP address automatically.
Set DNS
Select this option if you want to manually enter the DNS Server IP address(es). Fields to enter the Primary
Manually:
and Secondary DNS server IP addresses will appear after you select this option.
Primary DNS
Server:
Enter the Primary DNS server IP address assigned by your ISP.
Secondary DNS
Server:
This is optional.
Clone MAC
The default MAC address is set to the MAC address on the AP (Access Point). You can click the Clone Your
Address:
PC's MAC Address button to replace the AP's MAC address with the MAC address of your Ethernet card. It is not
recommended that you change the default MAC address unless required by your ISP.
D-Link DAP-1160 User Manual

PPPoE

20