The Resource Configuration Utility - Dell PowerEdge 2450 Installation And Troubleshooting Manual

      
You can easily correct certain system problems by verifying the correct settings in the
System Setup program. When you boot the system, the system checks the system
configuration information and compares it with the current hardware configuration. If
the system hardware configuration does not match the information recorded by the
System Setup program, an error message may appear on the screen.
This problem can happen if you changed the system's hardware configuration and for-
got to run the System Setup program. To correct this problem, enter the System
Setup program, correct the corresponding System Setup setting, and reboot the sys-
tem. See Chapter 4, "Using the System Setup Program," in the User's Guide for
detailed instructions on using the System Setup program.
        
If you are experiencing problems with the system, you may have a conflict between
the information stored by the System Setup program and the Resource Configuration
Utility. Although the Resource Configuration Utility can read changes from the System
Setup program, changes are not recorded into configuration memory until you run the
Resource Configuration Utility and save the new information. See Chapter 5, "Using
the Resource Configuration Utility," in the User's Guide for detailed instructions on
using the Resource Configuration Utility and saving new information.
If after using the Resource Configuration Utility you have not resolved the problem,
see Chapter 5, "Running the Dell Diagnostics."
2-6 Dell PowerEdge 2450 Systems Installation and Troubleshooting Guide