Advertisement
Quick Links
Centerset Lavatory Faucet with
Speed Connect™ Drain
Congratulations on purchasing your American Standard
faucet with Speed Connect drain, a feature found only on
American Standard faucets.
Speed Connect™ Drain*
• Fewer parts, installs in less time
• Never needs adjustment
• Guaranteed to seal properly the first time, every time.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Recommended tools
Screwdriver
1
1
INSTALL FAUCET
Turn off water at
CAUTION
main supply.
For single hole installation.
Make sure that O-RING (1) is installed into base of FAUCET (2).
For installation with DECORATIVE RING (3) (single hole installation) feed faucet
SUPPLIES (4) and CABLE CONNECTOR (5) through sink or mounting surface hole.
For installation with ESCUTCHEON PLATE (6) (for 3 hole, 4" centers installation)
use the following steps:
Unscrew and remove
Apply putty to underside of ESCUTCHEON PLATE (6) and
place over mounting holes.
Feed faucet tubes through O-RING (1) supplied with
ESCUTCHEON PLATE (6) and through the hole in the
ESCUTCHEON (6) and through SINK or DECK.
From below, push GASKET (7) and RETAINER PLATE (8)
over STUD (9) and secure with NUT (10) Before final
tightening, adjust faucet so that it is centered over
mounting hole.
Channel Locks
Fig. A.
Fig. B.
DECORATIVE RING (3) from FAUCET BODY (2).
Fig. A.
SINGLE HOLE
INSTALLATION
Installation
Instructions
3808.101
3
2
4
1
9
7
8
5
10
1
Certified to comply with ANSI A112.18.1
5 1 3 1 4 R e v . 1 . 3
Adjustable Wrench
Fig. B.
INSTALLATION WITH
ESCUTCHEON PLATE
2
3
9
PUTTY
7
8
10
1
4
6
5
Advertisement
Related Manuals for American Standard Jasmine Amarilis 3808.101
Summary of Contents for American Standard Jasmine Amarilis 3808.101
- Page 1 Centerset Lavatory Faucet with Speed Connect™ Drain Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets. Speed Connect™ Drain* • Fewer parts, installs in less time • Never needs adjustment •...
- Page 2 POP-UP DRAIN Remove CLEAR PLASTIC COVER (1). Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3). Tighten TAILPIECE (4) on DRAIN BODY before Fig. B. installing DRAIN BODY. REMOVE FLANGE Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) Fig.
- Page 3 ATTACH CABLE CONNECTOR Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and hand tighten. Fig. A. Your new POP-UP DRAIN installation is now complete. Fig. B. Note: Tailpeice on pop-up drain is 1-1/4” O.D. Fig. B. CHECK OPERATION OF POP-UP Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes.
- Page 4 TEST INSTALLED FITTING With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks. Remove AERATOR (3). Operate HANDLE (1) to flush water lines thoroughly. Replace AERATOR (3). CHECK DRAIN CONNECTIONS Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK.