Advertisement
X-Press
1-03-2002
11:54
Operating instructions:
The gas is turned on and off at the cylinder. The heat input and spark for ignition are control-
led by the knob situated on the top right hand side.
Lighting the heater:
1
Turn on the gas cylinder by either:
a Turning the cylinder valve anti-clockwise where a screwed cylinder connection is used.
or b Turn the black switch clockwise so that it points towards the flame
symbol where a switch-on system is used (Model No. 182H).
or c Turn the switch anti-clockwise to the ON (60' clock) position (Model
No. 541101).
2 Fully depress the grey button (
(if pilot flame does not ignite, repeat the above mentioned operations). Continue to fully
depress the grey button for a further 20 seconds to allow the thermocouple probe to heat
up, then release.
3 Turn the thermostat knob anticlockwise on position 6 and allow all three burners to heat
up.
When the room has reached the desired temperature, slowly rotate the thermostat knob
clockwise until the side burners turn off.
In this way the appliance will maintain the desired room temperature automatically chan-
ging from maximum input (
Turning off the heater:
The heater will only be totally "OFF" when the supply of gas from the cylinder has been turned
"OFF" after use the appliance must be turned "OFF" at the valve.
a Turning the cylinder valve clockwise where a screwed connection is used.
or b Turning the black switch anti-clockwise so that it points in the horizon-
tal position if a switch-on system is used (Model No. 182H).
or c Turn the switch clockwise to the OFF position (Model No. 541101).
DO NOT ATTEMPT to relight until FIVE minutes have elapsed.
Warning for switch-on system:
when the heat is alight, never turn the switch on the cylinder to the disconnect position. Wait
until heater and pilot go out, then and only then, should the switch be turned to the discon-
nect position if the cylinder requires changing.
FOR MODEL No. 182H
If the black switch of your regulator is fitted with a centre button this
must be depressed before turning to the disconnect position.
FOR MODEL No. 541101
With the regulator switch in the OFF position, lift the disconnect lever and lift
the regulator from the cylinder valve.
It is dangerous to switch to the disconnect position when the heater is alight.
573627/10.95
Pagina 7
) for 10 seconds and push 2 or 3 times the red button (
) to low input ( ) and viceversa.
ON
)
OFF
DISCONNECT
7
Advertisement
