Keypad Lock; Fan Heater; Maintenance - DeLonghi Fivy Vertical Instructions Manual

4.5.5 KEYPAD LOCK

It is possible to lock the remote control keypad to avoid ac-
GB
To activate the function, press the "Mode"
and "+" keys together and hold them both
down until the icon
splay.
To unlock the keypad, press the same two keys together as
before.
The "Keypad Lock" icon will no longer appear on the LCD.
IMPORTANT:
The "Keypad Lock" function does not inhibit the
"Standby" key. This is therefore always active, even
when the "Keypad Lock" function is enabled.

4.5.6 FAN HEATER

The "Fan Heater" function is only available on the radiators
equipped with fan heater. It is not available on this product.
command reception but it does not modify its current state.
ATTENTION:
on the display of the remote control.
4.6 OPERATION WITH COMMAND STAND-
BY KEY
The "Standby" key, located at the bottom of the appliance
(see Fig. 8) can be used to turn the radiator on and off with-
out the remote control.
To turn the appliance on and off, press the "Standby" key.
The radiator comes on in "Pilot Wire" mode and emits a
beep. The LEDs change colour accordingly (see page 16 for a
description of the colours). If the Pilot Wire is connected and
the programming unit is active, the appliance performs the
"Pilot Wire" order set on the programming unit. Otherwise it
performs the "Comfort" order.
The appliance emits a double beep when it enters the
"Standby" mode and a single long beep when it exits the
"Standby" mode.
When the radiator is turned on using the "Standby" Control
key, the "Comfort" temperature is set at 19°C and all func-
tions are reset to the default values.
◊
appears on the di-
22
To go back to controlling the appliance using the remote
control, turn the radiator on using the "Standby" key on the
remote control. The appliance starts operating with the
modes, temperatures and functions set on the remote con-
trol.
IMPORTANT: After using the "Standby" key on the Com-
mand the device ignores all orders transmitted by the re-
mote control other than "Standby" and emits three beeps to
indicate the error.
IMPORTANT: In case of power down due to a black-out, all
the current settings are kept in memory for about 1 hour
and a half. At recovery from power down after 1 hour and a
half, the appliance goes to the previously selected operating
mode, loosing the hour and day of the week.
If the power down happens when the radiator is in "Chrono"
mode and the recovery takes place after 1 hour and a half,
the appliance goes to "Comfort" mode with temperature set
point 17 °C.
mand is sent from the RCU.
IMPORTANT: If the appliance remains without power while
the "Overdrive (2h)" function is enabled, the time remaining
until the end of the two hour period is retained for about one
and a half hours. After this time, when power is restored the
date and time settings are lost. The appliance exits the func-
tion and operates in the mode selected previously.
5. CLEANING
Before cleaning, make sure the appliance is turned
off, cold and disconnected from the household
mains.
To clean, just wipe with a soft damp cloth and
neutral detergent. Never use abrasive or corrosive
cleaning products or solvents.
surface and inside of the appliance at least twice a
year using a vacuum cleaner.

6. MAINTENANCE

Should any technical problems arise, contact a
by the dealer or manufacturer) or your local dealer.
-