Warranty Information - Firex ADC Owner's Manual

PROBLEM
Smoke alarm does not sound when
tested
NOTE: Push test button for at least five
(5) seconds while testing!
The horn makes 2 quiet beeps and one
loud beep when tested.
LED blinks and alarm beeps
simultaneously every 60 seconds.
LED blinks and 30 seconds later
alarm beeps – repeats at 60 second
intervals.
Smoke alarm sounds unwanted alarms
intermittently or when residents are
cooking, taking showers, etc.
Interconnected smoke alarms do not
sound when system is tested.
The alarm sounds different than I'm
used to. It starts and stops.
REPLACE OR RETURN THE ALARM IF THE PUSH-TO-TEST
FUNCTION DOES NOT OPERATE PROPERLY AFTER
FOLLOWING THE PROCEDURES OUTLINED ABOVE
(see REPAIRS on page 7).
5-YEAR LIMITED SMOKE ALARM WARRANTY AND
10-YEAR LIMITED ULTRALIFE U9VL-J LITHIUM BATTERY WARRANTY
(WHEN SOLD WITH INVENSYS CONTROLS AMERICAS SMOKE ALARM)
Invensys Controls Americas warrants to the original consumer purchaser each
new smoke alarm to be free from defects in material and workmanship under nor-
mal use and service for a period of five (5) years from the date of purchase. For
Invensys Controls Americas smoke alarms sold with an Ultralife U9VL-J 9-volt bat-
tery, Invensys Controls Americas warrants to the original consumer purchaser
each new Ultralife U9VL-J 9-volt battery to be free from defects in material and
workmanship under normal use and service for a period of ten (10) years from the
date of purchase. Invensys Controls Americas agrees to repair or replace, at its
option, any defective smoke alarm or Ultralife U9VL-J 9-volt battery (when sold
with Invensys Controls Americas smoke alarm) provided that it is returned with
postage prepaid and with proof of purchase date to Invensys Controls Americas.
This warranty does not cover damage resulting from accident, misuse or abuse or
lack of reasonable care of the product. This warranty is in lieu of all other express
warranties, obligations or liabilities. THE IMPLIED WARRANTIES OF MER-
CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO A
PERIOD OF FIVE (5) YEARS FOR THE SMOKE ALARM AND TEN (10) YEARS FOR
THE ULTRALIFE LITHIUM U9VL-J 9-VOLT BATTERY (WHEN SOLD WITH INVENSYS
CONTROLS AMERICAS SMOKE ALARM) FROM PURCHASE DATE. Some states do
not allow limitations on how long an implied warranty lasts, so the above lim-
itations may not apply to you. IN NO CASE SHALL INVENSYS CONTROLS
AMERICAS BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES
FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHAT-
SOEVER, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY ITS NEGLIGENCE OR
FAULT. Some states do not allow the exclusion or limitation of incidental or conse-
quential damages, so the above limitation or exclusion may not apply to you. This
warranty gives you specific legal rights, and you may also have other legal rights
which vary from state to state.
This smoke alarm's manufacture and distribution are licensed by the U.S. Nuclear
Regulatory Commission.
This product meets all the requirements of U.L. Standard 217.
To return Ultralife 10-year lithium batteries under warranty, include the
lithium battery, a note describing the nature of the difficulty, with proof
of date of purchase, postage and return postage prepaid to:
191 E. North Avenue
Carol Stream, Illinois 60188 USA
www.invensyscontrols.com
©2006 Invensys Controls

WARRANTY INFORMATION

ULTRALIFE BATTERIES, INC.
c/o INVENSYS CONTROLS AMERICAS
P.O. Box 622
1350 Route 88 South
Newark, NY 14513
SOLUTION
1. Check that AC power is turned on.
2. Turn off power. Remove smoke
alarm from mounting plate and:
a. check that connector plug is
securely attached.
b. check that battery is properly
attached to connector.
3. Clean smoke alarm.
The alarm is operating correctly. Model
ADC has a ramp-up test horn feature.
This allows you to release the test but-
ton before the alarm emits the loud
beeps.
1. Battery is low – REPLACE IT
IMMEDIATELY!
2. Be sure the red LED is extinguished
after replacing the battery.
Unit inoperable. REPLACE OR RETURN
FOR REPAIR IMMEDIATELY!
1. Hire an electrician to move smoke
alarm to a new location. See SMOKE
ALARM PLACEMENT
2. Clean smoke alarm.
See "Cleaning" in the MAINTE-
NANCE AND CLEANING section.
Press and hold TEST button for at least
three seconds after the first unit sounds.
The alarm is operating correctly. This
alarm features the internationally rec-
ognized horn signal for evacuation. The
horn pattern is 3 short beeps followed
by a 2 second pause and then repeats.
8
110-762F