Cleaning; Troubleshooting; Practice Fire Safety; What To Do In Case Of A Fire - Firex ADC Owner's Manual

7. Connect a fresh, 9-volt battery to connector. The battery will fit
only one way. Be sure battery connector is securely attached
to battery terminals.
8. Place battery into battery pocket.
9. Close battery pocket door. Push down until it snaps into place.
10. Replace connector plug. Connector will snap into place.
Gently tug connector to be sure it is attached properly.
11. Reattach smoke alarm to mounting plate by turning smoke
alarm clockwise until it snaps into plate.
12. Turn on power and test smoke alarm using Push-to-Test button.

CLEANING

Clean the smoke alarm at least once a month to remove dust,
dirt, or debris. Always turn off power to smoke alarm before cleaning.
•
Using the soft brush or wand attachment to a vacuum cleaner,
vacuum all sides and cover of smoke alarm. Be sure all the
vents are free of debris.
•
If necessary, turn off power and use a damp cloth to clean
smoke alarm cover.
•
Do not spray smoke alarm with cleaners. Always place cleaners
on cloth first, then wipe smoke alarm with cloth.
IMPORTANT: Do not attempt to remove the cover or clean inside the
REPAIR
CAUTION: Do not attempt to repair this smoke alarm.
Doing so will void your warranty.
If smoke alarm is not operating properly, see TROUBLESHOOTING.
If necessary, and if still under warranty, return smoke alarm to
Invensys Controls Americas. Pack it in a well-padded carton, shipping
prepaid, with a note describing the nature of the problem and proof of
the date of purchase to:
If the smoke alarm is no longer under warranty, have a licensed
electrician replace the smoke alarm immediately with a compara-
ble Firex brand smoke alarm.

PRACTICE FIRE SAFETY

If the smoke alarm sounds its alarm horn, and you have not
pushed the test button, it is warning of a dangerous situation.
Your immediate response is necessary. To prepare for such
occurrences, develop family escape plans, discuss them with
ALL household members, and practice them regularly.
•
Expose everyone to the sound of a smoke alarm and explain
what the sound means.
•
Determine TWO exits from each room and an escape route to
the outside from each exit.
•
Teach all household members to touch the door and use an
alternate exit if the door is hot. INSTRUCT THEM NOT TO
OPEN THE DOOR IF THE DOOR IS HOT.
•
Teach household members to crawl along the floor to stay
below dangerous smoke, fumes, and gases.
•
Determine a safe meeting place for all members outside the building.

WHAT TO DO IN CASE OF A FIRE

1. Don't panic; stay calm.
2. Leave the building as quickly as possible. Touch doors to
feel if they are hot before opening them. Use an alternate
exit if necessary. Crawl along the floor, and DO NOT stop
to collect anything.
3. Meet at a pre-arranged meeting place outside the build-
ing.
4. Call the fire department from OUTSIDE the building.
5. DO NOT GO BACK INSIDE A BURNING BUILDING. Wait for
the fire department to arrive.
These guidelines will assist you in the event of a fire. However, to
reduce the chance that fires will start, practice fire safety rules
and prevent hazardous situations.
!
DANGER:
!
WARNING:
smoke alarm. THIS WILL VOID YOUR WARRANTY.
Invensys Controls Americas
Product Service Department
28C Leigh Fisher Blvd.
El Paso, TX 79906

TROUBLESHOOTING

Always turn off power at main fuse box
or circuit breaker before taking trouble-
shooting action.
DO NOT disconnect battery or AC
power to quiet an unwanted alarm.
This will remove your protection. Fan
the air or open a window to remove
smoke or dust.
7