Installing And Adjusting The Shoulder Harness - Ryobi RGBV3100 Operator's Manual

INSTALLING AND ADJUSTING THE SHOULDER
HARNESS
WARNING: Always use the shoulder
harness when using the unit to avoid
serious personal injury.
NOTE: Have the shoulder harness on and adjusted, but
not clipped to the support fitting prior to starting
unit.
1. Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 6).
3. Fully extend the harness.
4. Attach the metal clip of the shoulder harness to the
support fitting on top of the handle (Fig. 7).
Clip
ASSEMBLY INSTRUCTIONS
Clip
Fig. 6
Support Fitting
Fig. 7
5. Place the harness over your head and onto your
shoulder (Fig. 8).
6. While standing in the operating position (Fig. 8)
adjust length to fit the operator's size.
• Lengthen the harness by pulling down on the strap
and lifting the buckle end up (Fig. 9).
• Shorten the harness by pulling the strap back
through the buckle while holding the buckle (Fig. 9).
Fig. 8
Fig. 9
11