Operation And Programming - Henny Penny CF-941 Operator's Manual

3-6. OPERATION AND
PROGRAMMING
3-4
Unit Operation
Before operating the holding cabinet, read and
understand this complete operation manual (supplied
with each unit). The following steps are meant to be
guidelines, not complete operating instructions.
1. Turn POWER switch to the ON position.
2. The display will show the setpoint temperature.
Press the TEMP button at any time to view actual
temperature. The LED will light when the actual
temperature is on the display.
3. When temperature LED illuminates, the unit setpoint
temperature has been reached and product can be
loaded into the pans. Load product into a pan inside
the drawer and press appropriate timer button, either
1, 2, or 3.
4. At the end of the timing cycle, the display will flash
"0:00" and the timer LED will flash.
If more than one timer is running at the same time,
the timer with the least amount of time will be the
one displayed and the LED will be flashing,
indicating which timer is being displayed. Pressing
and releasing the SET button will toggle through the
different running times.
Temperature Setpoint Programming
Press and hold the TEMP button for 5 seconds, and the
setpoint temperature will start flashing and the LED will
turn off. Continue to hold in on the TEMP button, then
use the UP and DOWN buttons to set the desired setpoint
temperature. Releasing the TEMP button enters the
setpoint into the controls. If "Loc" shows in the display
when the UP or DOWN button is pressed, the controls
must be unlocked before temperature can be changed.
(See Special Program Mode).
Model CF-941
203