Nylatron Strips - Henny Penny 680 KFC Service Manual

3. Locate wire nuts and disconnect leads.
4. Remove the screw securing the ignitor in the bracket and
remove ignitor.
5. Make sure insulation is in place in the ignitor bracket and
slide the probe through the slot in the bracket.
The probe, or tip of ignitor, is very fragile. Take care
when installing the ignitor.
6. Secure ignitor in place with screw, reconnect wire leads
and replace side panel.
'7. Reconnect power and test the fryer for proper operation.
The nylatron strips fill the gap in the shroud behind the lid.
1. Secure the lid with the lid stop bracket.
2. Remove one of the tru-arc rings off of the lid pin and knock
the pin out of the lid.
3. Lift the lid from the unit.
The lid weighs 80 lbs. Care should be taken when lifting
the lid to prevent personal injury.
4. With one person on each lid arm, release arms from the
lid stop bracket and allow lid arms to rise all the way up.