Operating The Drill - Drill Master 69652 Owner's Manual & Safety Instructions

Drill Setup (cont.)
5. Set the desired torque setting by rotating
the Torque Adjustment Ring.
a. use the numbered torque settings from
1 to 20 for driving screws, bolts and nuts.
• Use a very low torque setting when first
driving small screws into soft materials.
Then adjust the setting as the proper
force required is determined.
• The torque setting required depends on the
item being driven. In the case of screws,
consider the size, length, and type of material.
• If a pilot hole has been drilled into the material,
a lower torque setting will be required.
b. use the setting marked by the
drill icon for drilling.
Workpiece and Work area Set up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.

Operating the Drill

1. Insert the fully charged Battery Pack into the base of
the Drill, making sure that it clicks into place securely.
Be sure the Battery Pack is securely seated into
the Drill Handle so it does not fall off during use.
2. Slide the Direction Switch (which should initially be
centered in the "lock" position) to the right for forward
drilling/fastening, or to the left for reversing the
operation. Use the "reverse" setting only to remove
screws or to release a jammed drill bit.
WaRninG! Do not change direction of rotation
while Chuck is rotating. Wait until Chuck has
come to a complete stop before changing direction.
3. If using the Drill to insert or remove screws, position
the driver tip in the item to insert or remove.
4. If drilling a hole, hold the Drill above the area to drill.
Operating the Flashlight
1. Insert fully charged Battery Pack into base of
Flashlight, making sure it clicks into place securely.
2. Adjust the Flashlight's head position by
rotating it up or down to click in place at
any of the three locking positions.
3. Press the Power Button to activate Light.
Item 69652 For technical questions, please call 1-800-444-3353.
c. In addition to single or double-ended screwdriver
bits, adapters with hexagonal shafts with
matching socket heads can also be used.
• Fix the torque setting low enough
to allow a safety margin.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
5. Press the Trigger to start the drill. The Work
Light will also activate once the Switch is
pressed and turn off once Switch is released.
6. When inserting or removing a screw or bolt, use
slight pressure at first to keep the screw driver bit in
the head of the screw or bolt and cause the screw
or bolt to thread into or unthread from the material.
7. When drilling a hole, let the Drill do the work,
using only enough pressure to follow the
drill as it cuts the hole in the material.
8. When finished using the Drill, release the
Trigger and center the Direction Switch to lock
the trigger mechanism as a safety measure.
9. Remove the Battery Pack.
10. Clean then store the Drill indoors
and out of children's reach.
4. When finished with the Flashlight, press the
Power Button again to turn off the Light.
5. Remove the Battery Pack.
6. Clean then store the Light indoors
and out of children's reach.
Page 9