Troubleshooting - Jensen MP1516BT Owner's Manual

TROUBLESHOOTING

Before going through the checklist, the check wiring connections. If any of the
problems persist after checking the list, contact your nearest service dealer.
Problem Cause
No power. • The car ignition switch is
• The fuse is blown.
Disc cannot • A disc is loaded inside the
be loaded or
ejected.
• The transport screws are
Disc does • The disc is inserted in the
not play
back.
• Incompatible disc is used.
• Disc is warped or scratched.
• The compact disc is
• The laser pickup is dirty.
• The temperature inside the
• Condensation.
No sound. • The volume is at minimum.
• The wiring is not properly
Sound skips. • The installation angle is
• The disc is extremely dirty.
• The disc is defective.
44
not on.
player.
installed.
wrong direction.
extremely dirty or defective.
car is too high.
connected.
greater than 30 degrees.
Solution
• If the power supply is
connected to the car
accessory circuits, but the
engine is not running, switch
the ignition key to "ACC".
• Replace the fuse. Make sure
the amperage matches the
specified value.
• Remove the disc in the player,
then insert a new one.
• Remove the two transport
screws from the top of the
unit.
• Insert the compact disc with
the label facing upward.
• Use a compatible disc.
• Use disc in good condition.
• Clean the disc with a soft cloth
or try to play a new one.
• Clean the laser pickup with a
cleaning disc.
• Cool off until the temperature
returns to normal.
• Turn the player off for an hour,
then try again
• Adjust the volume to a desired
level.
• Check the wiring connection.
• Adjust the installation angle
to less than 30 degrees.
• Clean the compact disc.
• Play a new compact disc.