Samsung D148W User Manual page 24

EN 13/ IF OPERATING ABNORMALITIES OCCUR
• THE INDICATOR LIGHTS
Problem
The salt light does not go out
The lights all light up one after
the other
A light flashes and the pro-
gramme does not start
• RELATING TO PROGRAMMING, DISPLAY
Problem
The cycle lasts too long
The appliance trips the circuit
breaker
The appliance does not start
Possible auses
C
- No salt or an insufficient quan-
tity of salt in the tank to trigger
the float.
- Wrong programme.
- Programme selector wrongly
positioned (between two not-
ches)
Possible auses
C
- The energy-saving program-
mes last longer because the
agitation and drying times are
longer to compensate for the
lower washing and drying tem-
peratures
- Insufficient amperage to sup-
ply all the appliances being
operated simultaneously.
- Internal fault in the appliance.
- No mains power to the socket.
- Tap closed (Cf. table fault d01).
- Water supply hose kinked.
- Selection error or programme
blocked.
- Start button pressed too long
(greater than 2 secs).
- Appliance in Safety mode (anti-
leak) (Cf. table fault d07).
24
What to do?
- Refill the tank and wait for the
cycle to end. If you have soft
water that requires no salt, the
light is constantly lit.
- Cancel the current program-
ming by holding down the Start
button for 3 seconds and then
re-programme.
- Reposition the selector on a
programme.
What to do?
- Use these programmes prefe-
rably at night when it is not so
important how long the pro-
gramme lasts or when it ends.
- Check the socket's amperage
(10A minimum) and the meter's
capacity.
- Call a technician.
- Check the socket and the fuse
- Check the tap is open.
- Check the hose line is OK.
- Cancel by holding down Start
for 3 secs and re-programme.
- Just press Start briefly to start
the programme.
- Call a technician.