Advertisement
D
C
C = Upper Brackets
D = Captive Screws
E = Captive nuts
Figure 4
Step 4. Designer™ and Ravenna™ gas Inserts - Pillar Face Assembly
Instructions:
a) Remove the backing plate and the two mounting brackets from
the box.
b) The brackets should be positioned with the hooks pointing down
and the holes located toward the center of the backing plate (see
Figure 5). Secure each bracket with three 5/32" allen head screws
in the three holes in the backing plate as shown in Figure 6.
Step 5. Designer and Ravenna gas Inserts - Air Deflector Installation
Instructions:
Packaged with the stove is an air deflector (see F in Figure 5).
Prior to installing the surround panels and pillar face, the air
deflector should be installed by loosening the two 5/32" hex
head screws (see G in Figure 5), positioning the deflector so the
tabs are down and the bent edge is facing the front of the insert,
sliding the tabs on the deflector behind the surround brackets,
and then retightening the screws.
Step 6. Designer and Ravenna gas Inserts - Backing Plate Installa-
tion Instructions:
The mounting brackets just installed on the backing plate have
two hooks on them. To install the backing plate on the Designer
and Ravenna inserts, lift the backing plate and place the hooks
on the brackets over surfaces H and I (see Figure 5) on the side
surround brackets.
E
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Turn Deflector so Bent Edge Faces the Front
g
Front view of Designer™ and Ravenna Inserts
F = Air Deflector
h = Side bracket upper mounting surface
g = hex head Screws
I = Side bracket lower mounting surface
Figure 5
Backing Plate for
Designer and Ravenna Inserts
Figure 6
Step 7. All Models - Pillar Installation Instructions:
There is a hole in the top of each pillar (see J in Figure 7). With
the pillar upright (hole J on top) and the vertical fluting to the
outside, place the bottom of the pillar in the semicircular hole in
the cast bottom, while sliding hole H down over hanging bracket
K. Repeat this procedure for the other pillar.
F
h
I
Rear view of
Backing Plate
3
Advertisement
