Lennox Hearth Products SHADOWDANCE LSVFSD-LP Installation And Operation Instructions Manual
Lennox Hearth Products SHADOWDANCE LSVFSD-LP Installation And Operation Instructions Manual

Lennox Hearth Products SHADOWDANCE LSVFSD-LP Installation And Operation Instructions Manual

Vent-free millivolt dual-listed gas log sets shadowdance series

Advertisement

Installer: Leave This Manual With The Appliance.
Consumer: Retain This Manual For Future Reference.
I
n the Commonwealth of Massachusetts:
• Installation must be performed by a licensed plumber or gas fitter
• See Table of Contents for location of additional
Commonwealth of Massachusetts requirements
• Hot! Do not touch! This appliance will be hot during operation and will retain heat for a while after
shutting off the appliance. Severe burns may result.
• Carefully supervise children in the same room as appliance.
• Improper installation, adjustment, alteration, service or maintenance can cause injury or property
damage. Refer to this manual. For assistance or additional information consult a qualified installer,
service agency or the gas supplier.
• Do not build a wood fire. Do not burn wood or other material in these appliances.
• Carefully review the instructions supplied with the decorative type unvented room heater for the minimum fire-
place size requirement. Do not install the appliance in the fireplace, unless the fireplace meets the minimum
dimensions required for the installations (see Page 3).
• This is an unvented gas log appliance. It uses air (oxygen) from the room in which it is installed. Provisions for adequate
combustion and ventilation air must be provided. Refer to Combustion and Ventilation Air Section on Page 5.
• Important: Read and understand these instructions completely before installing your unvented room heaters.
• This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible
for use with other gases. If the gas supply differs, DO NOT INSTALL the appliance. Contact your dealer to obtain
the correct appliance.
• This appliance may be installed in an aftermarket, permanently located, manufactured (mobile) home, where
not prohibited by local codes.
• Lennox™ vent-free gas logs are designed for use as a supplemental heater. They are not intended for continuous use
as a primary heat source.
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow your gas supplier's instructions.
• If your gas supplier cannot be reached, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the gas supplier
INSTALLATION AND OPERATION INSTRUCTIONS
Vent-Free Millivolt
Dual-Listed Gas Log Sets
Gas Train Models:
Log Set Models:
LSVFSD-NG
LSVFSD-18 Logs
LSVFSD-LP
LSVFSD-24 Logs
Log Sets Sold Separately
P/N 850,051M Rev. A, 08/2007
US
Report No.116-L-49-5
WARNINGS
Shadowdance™ Series
.
TM

Advertisement

Table of Contents
loading

Summary of Contents for Lennox Hearth Products SHADOWDANCE LSVFSD-LP

  • Page 1 Dual-Listed Gas Log Sets Gas Train Models: LSVFSD-NG LSVFSD-LP Log Sets Sold Separately Installer: Leave This Manual With The Appliance. Consumer: Retain This Manual For Future Reference. n the Commonwealth of Massachusetts: • Installation must be performed by a licensed plumber or gas fitter •...
  • Page 2 IMPORTANT SAFETY AND WARNING INFORMATION READ THIS MANUAL IN ITS ENTIRETY AND UNDER- STAND THESE RULES TO FOLLOW FOR SAFETY. WARNINGS If the information in this manual is not fol- lowed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
  • Page 3: Table Of Contents

    CONGRATULATIONS ON THE PURCHASE OF YOUR NEW GAS APPLIANCE MANUFACTURED BY LENNOX HEARTH PRODUCTS. When you purchased your new gas-log heaters, you joined the ranks of thousands of individuals whose answer to their home heating needs reflects their concern for efficiency and our environment. We extend our continued support to help you achieve the maximum benefit and enjoy- ment available from your new gas-log heater.
  • Page 4: Tools Required

    SEE TABLE 3 ON PAGE 16 FOR BTU INPUT AND GAS PRESSURE REQUIREMENTS Do not install these Dual-Listed Gas Log Appliances in a bedroom or a bathroom as all units exceed maximum allowable BTU/hr input of 10,000. Tools and Supplies Normally Required external regulator (Propane models only) manual shut-off valve sediment trap...
  • Page 5: Requirements For The Commonwealth Of Massachusetts

    Requirements for the Commonwealth of Massachusetts Note: The following requirements reference various Massachusetts and national codes not contained in this document. un-vented room Heaters shall be installed in accordance with 57 cmr 0.00 and 48 cmr .00 through 7.00: (a) Permits and inspections: in addition to complying with 48 cmr .05 the following requirements must be satisfied: 1.
  • Page 6: Preinstallation

    4. compare the maximum Btu/Hr the space can support with the actual amount of Btu/Hr used. _________ Btu/Hr (max. the space can support) _________ Btu/Hr (actual amount of Btu/Hr used) Example: 61,440 Btu/Hr (max. the space can support) 71,000 Btu/Hr (actual amount of Btu/Hr used) the space in the above example is a confined space because the actual Btu/Hr used is more than the maximum Btu/Hr the space can support.
  • Page 7 16" Min. Figure 2 - Clearances Step 2. Ceiling Clearance: the ceiling must be at least 4" from the top of the appliance opening (Figure 2). Step 3. Noncombustible materials (minimum requirements): to install the appliance without wood mantels, shelves or other combustible projec- tions directly above the opening of the fireplace (firebox) refer to Figure 3 and Table 1.
  • Page 8: Installation

    Example: The bottom of the mantel may project from the wall a maxi- mum of 2-1/2" at a minimum of 8" above the opening. The top shelf of the mantel may project a maximum of 6" at a minimum of 14-1/2" above the opening.
  • Page 9: Gas Pressure Check

    the appliance gas inlet connection is /8" NPt at the regulator/valve, located on the left side facing the appliance. if a right side connection is required, the connection pipe may be piped under the rear of the appliance to end at the left hand side for connection to the inlet. When tightening up the joint to the regulator hold the regulator securely with a wrench to prevent the regulator from moving.
  • Page 10: Log Placement Instructions

    LOG PLACEMENT INSTRUCTIONS 1. Place rear ember bed as shown in Figure 11. Top Burner Locating Pins Rear Ember Bed Position Ember Bed All the Way Forward in Gas Train Assembly Figure 11 - Install Rear Ember Bed . Place rear log onto the two rear grate locating pins as shown in Figure 12 (the locating pins are outlined in Figure 11).
  • Page 11 5. Place left top log onto rear log and middle log locating pins as shown in Figure 15. Left Top Log Locating Pins Figure 15 - Install Left Top Log 6. Place the center top log onto the rear log locating pin and middle log locating pin as shown in Figure 16.
  • Page 12: Burner Flame Appearance

    WARNING Failure to position the parts in accordance with Figure 21 or failure to use only parts specifically approved with this appliance may result in property damage or personal injury. Periodically check the positioning of all logs. Flame Appearance REFER TO THE OPERATING INSTRUCTIONS LOCATED AT THE BACK OF THIS MANUAL BEFORE LIGHTING THE APPLIANCE TO OBSERVE THE FLAMES.
  • Page 13: Operation And Care

    OPERATION AND CARE OF YOUR APPLIANCE 1. Appliance operation may be controlled through the ON/OFF unit rocker switch, located in the bottom front of the appliance or through an optional remote control. . When lit for the first time, the appliance will emit an odor for an hour or two.
  • Page 14 ACCESSORY COMPONENTS Standard Remote Control System (Model RCL) the model rcl (standard) remote control system, features a simplistic on/off control function for the fireplace. this model includes a hand-held transmitter, a remote receiver with wall-mount cover plate and all hardware required to install the unit.
  • Page 15 ACCESSORY COMPONENTS (CONTINUED) Gas Log Sets 18" Gas Log Set 24" Gas Log Set Gas Log Sets* Cat. No. Model No. H5137 LSVFSD-18 Logs Shadowdance™ 18" Logs H5138 LSVFSD-24 Logs Shadowdance 24" Logs * For use with gas train models LSVFSD-NG and LSVFSD-LP only Charred Ember Kit an optional -piece charred ember Kit is available to enhance the beauty of the log set.
  • Page 16: Millivolt Wiring Diagram

    CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. If any of the original wire as supplied must be replaced, it must be replaced with Type AWM 105°C – 18 GA. wire. OPTIONAL REMOTE CONTROL (MILLIVOLT)
  • Page 17: Operating Instructions - Millivolt

    WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. this appliance has a pilot which must be lighted with a piezo igniter. When lighting the pilot, follow these instructions exactly.
  • Page 18: Troubleshooting Guide

    VENTED/UNVENTED TROUBLESHOOTING GUIDE OBSERVED PROBLEM 1. When igniter button is A. igniter electrode positioned wrong. pressed, there is no spark B. igniter electrode broken. at oDs/pilot. C. igniter electrode not connected to igniter cable. D. igniter cable pinched or wet. E.
  • Page 19: Replacement Parts List - Millivolt

    REPLACEMENT PARTS LIST (MILLIVOLT) - SHADOWDANCE™ SERIES Replacement Parts List (Millivolt) - Shadowdance™ Series, Models LSVFSD-NG and LSVFSD-LP (18" and 24") Description Valve, millivolt (Natural) Valve, millivolt (Propane, l.P.g.) ember Bed Front ember Bed rear Bottom Burner top Burner Piezo igniter oDs Pilot assembly, millivolt (Natural) oDs Pilot assembly, millivolt (Propane, l.P.g.) Knob extension, Pilot/on/off...
  • Page 20 lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. consult your local distributor for fireplace code information. Printed in u.s.a. © 007 by lennox Hearth Products P/N 850,051M REV.

Table of Contents