Impex MARCY DIAMOND ELITE SM-1050 Owner's Manual page 7

STEP 2 (See Diagram 2)
A.) Do not tighten Nuts and Bolts until instructed to do so.
B.) Attach the Left Upright Beam (#1) to the Left Rear Support (#4) and the left Base
Frame (#6).
C.) Secure it to the Base Frame with two M10 x 3 ½" Allen Bolts (#34), four Ø ¾"
Washers (#38), and two M10 Aircraft Nuts (#37).
D.) Secure it to the Left Rear Support with one M10 x 3 1/8" Carriage Bolt (#30), one
Ø ¾" Washer (#38), and one M10 Aircraft Nut (#37) from the side. Secure with
one M10 x 2 1/8" Carriage Bolt (#28), one Ø ¾" Washer (#38), and one M10
Aircraft Nut (#37) from the top.
E.) Repeat A to D to install the Right Upright Beam (#2).
F.) Slide Lower Safety Stop Frame (#13) onto a Guide Rod (#7). Slide one Safety
Stop Frame (#12) onto the Guide Rod. Insert the bottom of the Guide Rod into the
hole on the Left Rear Support. Secure it with one M10 x 3" Allen Bolt (#33), two Ø
¾" Washers (#38), and one M10 Aircraft Nut (#37).
G.) Attach the top of the Guide Rod to the bracket on Left Upright Beam. Secure it
with one M10 x ¾" (#31) and one Ø ¾" Washer (#38).
H.) Repeat F to G to install the Lower Safety Stop Frame, the Safety Stop Frame, and
the other Guide Rod to the other side.
6
DIAGRAM 2