Care And Maintanence, Weight Capacity, Operating Notes; Weight Capacity And Dimension - Impex MARCY MWM-7041 Owner's Manual

CARE AND MAINTENANCE
1. Lubricate moving parts with WD-40 or light oil periodically.
2. Inspect and tighten all parts before using the equipment.
3. The equipment can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
4. Examine the equipment regularly for signs of damages or wear.
5. Replace any defective components immediately and/or keep the equipment out of use until it
is repaired.
6. Failure to examine regularly may affect the safety level of the equipment.

WEIGHT CAPACITY AND DIMENSION

1. Maximum user weight to use Chin-up and Dip Handle: 300 lbs.
2. Maximum weight on Sliding Weight Post: 220 lbs.
3. Maximum weight on Weight Plate Rack: 410 lbs
4. Maximum weight on each Dumbbell-Kettlebell Tray: 265 lbs.
5. Maximum weight on Safety Catch and Bar Catch: 300 lbs.
6. The Cable system generates 1:1 ratio of resistance from the weights loaded on Sliding Weight
Post (part#20). Example, 100 lbs of weight plates generates 100 lbs of resistance.
7. Assembled Dimension: 56" x 61" x 85"
OPERATING NOTES
Cable Tension Adjustment
Adjust the tension of the Cable System by moving the lower Pulley position on the
Double Floating Pulley Brackets.
If the tension is too loose, move up the lower pulley by one hole.
If the tension is too tight, move the lower pulley down by one hole.
.
Lower Pulley
Caution
1.) Always remove Lat Bar and Short Chain after Lat Bar exercises.
2.) Ensure to remove Lat Bar and Short Chain from the Upper Cable to avoid Lat
Bar dropping off from Upper Frame.
©IMPEX INC.
7
www.impex-fitness.com