Impex MWM 2001 Owner's Manual page 7

STEP 3 (See Diagram 3)
A.) Attach the top of the Bench Press Frame (#23) to the top of the Vertical Frame (#16). Align the
holes and insert a M12 x 6 ½" Axle (#33) through the holes. Secure it with two
(#79) and M12 Aircraft Nuts (#36). Covered by two Cone-shaped Caps (#67). Make sure the
Bench Press Frame can rotate freely on the Axle.
B.) Attach the Left Butterfly Arm (#13) to the left bracket on the Bench Press Frame (#23). Insert a
M12 x 4" Axle (#34) through the holes. Secure it with two
Aircraft Nuts (#36). Covered the ends with two Cone-shaped Caps (#67). Make sure the Arms
can rotate freely on the Axle. Otherwise, release the nuts.
C.) Repeat the Step B above to install the Right Butterfly Arm (#12).
1 ½" Washers (#80) and M12
6
1" Washers
DIAGRAM 3