Moving Machine By Hand - Husqvarna P-ZT26 CE Operator's Manual

Moving Machine By Hand

WARNING!
No adjustments or maintenance
should be carried out unless:
• the engine stopped
• the ignition key removed
• the parking brake activated
When pushing or pulling the mower, engage the
bypass linkages with the hydro release levers. The
levers are located on each side of the rear of the unit
below the engine plate.
Raise the deck to the highest (transport) position.
Pull the bypass linkages up and out of the keyhole
slots. Release the lever with the head outside the
bracket and held into the bypass setting.
To reengage the hydro to drive, reverse the above
procedure.
WARNING!
Bypass linkages are located close
to the muffler. To prevent burns, the
engine should be shut off and allowed
to cool before the bypass linkage
levels are handled.
OPERATION
2
1. Release lever locked into the bypass position
2. Release lever, engaged
Right side, ZT-3400 linkage
1
8058-091
35