Stanley 2-Way Feed Chipper/ Shredder Owner's Manual page 6

Assembly
IMPORTANT:This unit is shippedwithout gasolineor oil in the engine.Be
certainto fill the enginewith gasolineandoil asinstructedbeforeoperating
yourmachine.
Requiredtools: A Philips head screw driver
1. Remove the chipper from its carton
Remove staples, break glue on top flaps, or cut tape at carton end and peel
along top flap to open carton.
Figure1
5. Attaching the chipperfunnel
• Thefirst step is to attachthe 2 handlesto the sidesof the funnel using
the wrenchprovidedanda Phillipsheadscrewdriver (Figure3). Tighten
the nuts securely.
• Thesecondstep is to placethe funneloverthe openingon the chipper
box,ensuringthe rubbergasketis correctlyaligned. Securethe funnel
usingthe two "swing upbolts" andthe onefixed bolt usingthe wrench
provided. Tightenthe nuts securely (Figure4).
Figure3 Figure4
2. Verify all parts in the chipper carton(See Figure1)
• ChipperFunnel
• Chipperengineandboxassembly (pre-assembled)
• ChipperChute
• HardwareBag
• Trailerhitch andfunnelhandlespackaged together
5. Attachingthe Side Chipper Chute
• Placethe chipperchuteoverthe
four bolts protrudingfrom the
side of the chipperboxand
securethe nuts tightly usingthe '
wrenchprovided(Figure5).
Figure2
3. Verify all parts in the hardware bag(See Figure2)
• Hearingprotection
• Gloves
• Goggles (eyeprotection)
• Oil fill funnel
• Chipcollectionbag
• Wrenchfor assemblyof the chuteandfunnel
• Hardwarebagwith a spareblade
Figure 5
6. Attachingthe chip collection bag
• Placethe metal grommetsof the bagoverthe wire loopslocatedat the
baseof the engine. Wrapthe bagunderthe bottomof the discharge
chuteandpull the drawstringtightly andsecureit.
7. Attachingthe trailer hitch
• Placethe trailer hitch into the socketat the baseof the chipperoverthe
axle assembly. Insertthe pin andsecurewith the locking c otterpin.
8. Re-connectthe sparkplug wire
Rev. 9/2010 STANLEY is a registered trademark of The Stanley Works or its affiliates and are used under license by GXi Outdoor Power LLC.
6 of 12