Hard Disk Write Protect - American Megatrends MB950 User Manual

Advanced
Main
IDE Configuration
Mirrored IDER Configuration
Configure SATA#1 as
SATA#1 IDE Configuration
SATA#2 IDE Configuration
► Primary IDE Master
► Primary Slave Master
► Secondary IDE Master
► Secondary IDE Slave
► Third IDE Master
► Fourth IDE Master
► Primary IDE Master
► Fifth IDE Master
► Fifth IDE Slave
► Sixth IDE Master
► Sixth IDE Slave
Hark Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
Jmicron 36x ATA Controller
The IDE Configuration menu is used to change and/or set the
configuration of the IDE devices installed in the system.

Hard Disk Write Protect

Disable/Enable device write protection. This will be effective only if
device is accessed through BIOS.
IDE Detect Time Out (Sec)
Select the time out value for detecting ATA/ATAPI device(s).
ATA(PI) 80pin Cable Detection
Select the mechanism for detecting 80pin ATA(PI) cable.
Jmicron 36x ATA Controller
Select ATA Controller Operate Mode
BIOS SETUP UTILITY
PCIPnP Boot
[Enabled]
[IDE]
[Compatible]
[Enhanced]
: [Hard Disk]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
{Disabled}
[35]
[Host & Device]
[Enabled]
MB950 User's Manual
BIOS SETUP
Security Chipset
<- Select Screen
↑↓ Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Exit
27