Table of Contents
Advertisement
Re-Fitting the Components to the Cooktop
a. Refit the trivet supports to the Cooktop, ensuring
that the trivet supports are correctly fitted.
NOTE:
It is imperative that the trivet supports are correctly
re-fitted to the appliance to ensure that the burners
and trivets locate correctly and sit flush and level.
Note the orientation of the trivet supports when
refitting. The trivet support front side rail profiles are
different from the rear side rail profiles and will only
fit one way to the cooktop.
b. Refit burners and burner caps onto the cooktop.
c. Refit the trivets to the cook top, taking note that
the trivets are manufactured with a lip on one
edge, the lip must always be fitted to the outer
edge (front and back) of the range.
d. Refit the spill / grease tray(s) to the range.
Oven Interior
a. Do not use wire brushes, steel wool or other
abrasive materials to clean the oven interior.
b. Clean the oven regularly with a good quality
domestic oven cleaner.
c. Once a week, remove and clean any built up of
grease etc. from the oven racks and the bottom
spill over cover.
d. Dry the oven thoroughly with a dry cloth and
polish with a soft dry cloth.
Periodic Maintenance
NOTE:
All maintenance operations should only be carried
out by a qualified service person.
To achieve the best results, cleaning must be
regular and thorough. All controls and mechanical
parts should be checked and adjusted periodically
by a qualified service person. If any small faults
occur, have them attended to promptly. Don't wait
until they cause a complete breakdown. It is
recommended that the appliance is serviced every
6 months.
Part 5
Cleaning and Maintenance
Gas Control Valve Re-Greasing
The gas control valve should be dismantled and
greased every 6 months to ensure the correct
operation of the gas control valve.
To carry out this operation;-
a. Remove the gas control knobs from the gas tap
spindles by pulling the knobs away from the
control panel.
b. Remove the drip tray from the appliance.
c. Remove two screws on the underside of control
panel, securing the control panel to the hob.
d. Remove the control panel from the front of the
appliance.
e. Remove 2 screws holding shaft plate to gas
control body and remove control shaft and
plate. Note orientation of shaft for correct
re-assembly.
Two Screws
f. Using needle nose pliers or similar, pull out gas
control spindle, again noting its orientation.
g. Apply a suitable high temperature gas cock
grease or lubricant such as ROCOL - A.S.P (Anti
scuffing paste) / Dry Moly Paste to the outside of
the spindle.
h. Replace spindle and re-assemble the gas
control in reverse order.
i.
Refit the control panel to the appliance and
secure with 2 screws.
j.
Refit the knobs to the gas control valve spindles.
12
Spindle
Advertisement
Table of Contents
