IrDA Infrared Module Header: IR2
The connector allows you to connect to IrDA Infrared module. You
must configure the setting through the BIOS setup to use the IR function. The
IR2 is compliant with Intel
Event Input Connector: J14
This connector is used to link the Event Input Button to facililtate the
management of the remote platforms in connection. When event inputs are
detected, push the button and the signal indicator of the remote platform where
the event inputs originated will be lit. The J14 works only when National
®
Semiconductor
PC87431HM server management controller is onboard.
®
Front Panel I/O Connectivity Design Guide.
IR2
5
6
Hardware Setup
1
2
Pin Definition
Pin
Signal
1
NC
2
NC
3
VCC5
4
GND
5
IRTX
6
IRRX
J14
2-17