Table of Contents
Advertisement
Hardware Installation
If you set status to manual and configure VJ1 switch to the settings that
match your CPU voltage as follow table:
VJ1
1
2
Auto OFF OFF OFF OFF OFF 1.475 OFF OFF OFF OFF ON
1.100 ON OFF OFF OFF OFF 1.500 ON OFF OFF OFF ON
1.125 OFF ON OFF OFF OFF 1.525 OFF ON OFF OFF ON
1.150 ON
ON OFF OFF OFF 1.550 ON
1.175 OFF OFF ON OFF OFF 1.575 OFF OFF ON OFF ON
1.200 ON OFF ON OFF OFF 1.600 ON OFF ON OFF ON
1.225 OFF ON
1.250 ON
ON
1.275 OFF OFF OFF ON OFF 1.675 OFF OFF OFF ON
1.300 ON OFF OFF ON OFF 1.700 ON OFF OFF ON
1.325 OFF ON OFF ON OFF 1.725 OFF ON OFF ON
1.350 ON
ON OFF ON OFF 1.750 ON
1.375 OFF OFF ON
1.400 ON OFF ON
1.425 OFF ON
1.450 ON
ON
2-3.6 CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory by
momentarily shorting pins 2-3 on jumper JP5, for a few seconds. Then
restore JP5 to the initial 1-2 jumper setting in order to recover and retain
the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Short pin 2-3 for
JP5 Setting
at least 5 seconds to
clear the CMOS
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
3
4
5
ON OFF OFF 1.625 OFF ON
ON OFF OFF 1.650 ON
ON OFF 1.775 OFF OFF ON
ON OFF 1.800 ON OFF ON
ON
ON OFF 1.825 OFF ON
ON
ON OFF 1.850 ON
Clear CMOS Data
39
VJ1
1
2
ON OFF OFF ON
ON
ON OFF ON
ON
Retain CMOS Data
Short pin 1-2
to retain new
settings
1 2 3
SY-K7ADA XP
3
4
ON OFF ON
ON OFF ON
ON
ON
ON
ON
ON
ON
1 2 3
5
ON
ON
ON
ON
ON
ON
ON
ON
Advertisement
Table of Contents
