Table of Contents
Advertisement
Charging the Wireless Telephone
Chargers are shipped with the appropriate power supply for the site's location. Connect
the Stand or Charger to an appropriate wall outlet via its power supply and it's ready for
use. Chargers operate in a 50° to 85° F (10° to 30° C) environment. Do not expose them
to freezing temperatures or direct sunlight.
The Dual Battery Charger
The Dual Battery Charger is a two-slot desktop charger designed to charge
the Nickel Metal Hydride (NiMH) Battery Packs required to operate Wireless
Place the Dual Battery Charger on a flat, horizontal surface.
The user must end any call in progress by pressing the
Telephone before placing the handset into the Charger. Place the Wireless Telephone in
the front compartment facing forward. It may be on or off during charging. A spare
Battery Pack may be placed in the rear slot. Either slot can be chosen to take priority.
The first Battery Pack placed into either slot is charged first.
There are two indicator lights, one for each charging slot. Verify that the light for the
corresponding slot comes on when a Wireless Telephone or Battery Pack is placed into a
charging slot. The light turns off when the Charger is finished charging or a short time
after a fully charged Battery Pack is placed in a slot. An indicator light will not come on
when the slot is empty, when a Battery Pack is improperly seated or is the wrong type, or
when the Charger has no power applied. A fast flash indicates the Battery Pack is not
charging and must be replaced.
Cleaning the Dual Battery Charger
Clean the Dual Battery Charger by wiping the surface with a clean, water-dampened cloth
or paper towel. A mild detergent solution may be used. Be sure to wipe away any
Telephones. Full charging is accomplished in
approximately two hours.
Only NiMH Battery Packs with a YELLOW label on the
handset contact side may be charged in the Dual Battery
Charger. Nickel-Cadmium (NiCd) and older NiMH Battery
Packs with a GREEN label will not charge. If the indicator
light does not come on when a Wireless Telephone or
Battery Pack is first placed in the Charger, check to make
sure the Battery Pack has a YELLOW label.
Do not place anything in the Dual Battery Charger other
than the Wireless Telephone. You might damage the
contacts. Bent contacts can keep the Wireless Telephone
from charging.
Using the Dual Battery Charger
3410 Wireless Telephone User Guide
key on the Wireless
END
Page 5
Advertisement
Table of Contents
