Removing The Machine Control Electronics - Whirlpool Duet Sport WED8300SW Manual

REMOVING THE MACHINE CONTROL ELECTRONICS

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the rear screws from the top
cover of the dryer.
4. Lift the rear of the cover, pull back, and
remove the cover from the dryer.
Top Cover Screws
Machine Control
Electronics Assembly
5. Remove the front machine control elec-
tronics (MCE) bracket screw.
MCE Bracket Screw
6. Remove the screw from the MCE, un-
hook the tabs from the bracket, and re-
move the electronics.
7. Disconnect the wire connectors from the
MCE board at P8, P9, P13, P14, and the
black and red wires from relay K2.
RD BK P8
4-4
MCE Screw
P9 P13 P14
MCE Board