Additional Features - Whirlpool Duet Sport WED8300SW Manual

ADDITIONAL FEATURES

WRINKLE SHIELD
™
The WRINKLE SHIELD
out wrinkles that form when you cannot unload
the dryer promptly at the end of a cycle. During
this option, the dryer stops tumbling and then
tumbles again for a brief period.
• Press the WRINKLE SHIELD
get up to 90 minutes of heat-free, periodic
tumbling at the end of a cycle.
• During the WRINKLE SHIELD
may continue the option after opening and
closing the dryer door by pushing START.
• Cancel at any time by pressing the WRINKLE
SHIELD feature button.
™
NOTE: If you do not select the WRINKLE
SHIELD feature, the dryer stops after the
™
cool down period.
Temperature
Temperature settings are used with the Manual
Cycles. Press TEMP ADJUST until the desired
temperature setting illuminates. Tempera-
ture modifiers cannot be used with the Auto
Cycles.
Air Only
Use the Air Only modifier for items that require
drying without heat such as rubber, plastic
and heat-sensitive fabrics. This chart shows
examples of items that can be dried using Air
Only.
Type of Load
Foam rubber - pillows, padded bras, stuffed toys
Plastic - Shower curtains, tablecloths
Rubber-backed rugs
Olefin, polypropylene, sheer nylon
* Reset time to complete drying, if needed.
Feature
feature helps smooth
™
feature to
™
feature, you
™
Time*
(Minutes)
20 - 30
20 - 30
40 - 50
10 - 20
When using Air Only
• Check that coverings are securely
stitched.
• Shake and fluff pillows by hand periodically
during the cycle.
• Dry item completely. Foam rubber pillows
are slow to dry.
NOTE: Auto Cycles are not available when you
are using the Air Only setting.
End of Cycle Signal
The End of Cycle Signal produces an au-
dible sound when the drying cycle is finished.
Promptly removing clothes at the end of the
cycle reduces wrinkling.
Press and release the END OF CYCLE SIGNAL
to turn off the signal.
Hold the END OF CYCLE SIGNAL for 3 sec-
onds to lock or unlock this control.
NOTE: When the WRINKLE SHIELD
selected and the End of Cycle Signal is on, an
audible sound will be emitted every 5 minutes
until the clothes are removed, or the WRINKLE
SHIELD feature is finished.
™
CHANGING CYCLES, OPTIONS
AND MODIFIERS
You can change Auto Cycles, Timed Cycles,
Modifiers and Options anytime before press-
ing Start.
• Three short tones sound if an unavailable
combination is selected. The last selection
will not be accepted.
Changing Cycles after pressing Start
1. Press STOP twice. This ends the current
cycle.
2. Select the desired cycle and options.
3. Press and hold START. The dryer starts at
the beginning of the new cycle.
3-6
feature is
™