Whirlpool Duet Sport WED8300SW Manual page 29

Remove the door assembly
1. Remove the 4 screws that hold the door
hinge on the front panel of the dryer.
A
A. Dryer front panel
B. Door assembly
2. Lay the door assembly on a flat, protected
surface with the inside (inner door assem-
bly) facing up.
3. Remove the 6 Phillips head screws to re-
lease the outer door assembly from the
inner door assembly, as indicated below.
See illustration. It is important that you re-
move only the 6 indicated screws.
4. Lift the inner door assembly off the outer
door assembly.
5. Disengage locking tabs by rotating inner
ring clockwise. See illustration.
A
A. Inner ring
B. Outer ring
6. Turn inner ring 180° and lock tabs into
Reverse hinge
1. Use a small flat-blade screwdriver to re-
B
2. Remove hinge cover.
3. Remove the 4 screws that attach to the in-
B
2-21
place.
move 2 plug strips from the inner door.
Slide the head of the screwdriver under
the plugs, being certain not to scratch the
inner door surface. Lift up.
A
A. Door hinge
B. Plug strips
C. Hinge cover
ner door hinge and move the hinge to the
other side. Reinstall the 4 screws.
A. Door hinge
B
C
A