KitchenAid KFGS306VSS Technical Education page 28

6. Using a T20 TORX® screwdriver, remove
the orifice holder screws (C).
C A
A
B
C
A. Igniter electrode
B. Ori ce spud
C. Ori ce holder screws
D. Ori ce holder
7. On KFGU models only, lift the front part of
the cooktop and unhook the wire harness
to detach it from the glass control panel of
the metal cooktop.
On all models, remove the metal cooktop
and the sheet of insulation from the cooktop
base.
A
B
C
A. Metal cooktop
B. Sheet of insulation
C. Cooktop base
B
D
8. To Convert Right or Left Burners:
• Insert 7.0 mm nut driver down onto the gas
orifice spud and remove by turning it coun-
terclockwise and lifting out.
• Set gas orifice spud aside.
• Replace with correct Natural gas orifice spud.
See the Natural Gas Orifice Spud Charts.
C
9. To Convert Center Burners:
• Use 10.0 mm wrench to loosen and
remove the orifice.
• Replace with correct Natural gas orifice spud.
See the Natural Gas Orifice Spud Charts.
• Use Phillips screwdriver to loosen the venturi
screw. Slide the brass venturi into the injec-
tor, stop at the first groove (D) for Natural
gas conversions. Securely tighten the venturi
screw.
A. Ori ce
B. Venturi
C. Second Groove (16.0 mm
LP gas setting)
• Use 15.0 mm wrench to loosen the nut secur-
ing the tube to the orifice pack. Remove the
tube from the orifice pack.
A B
A. Tube
B. Attachment nut (15.0 mm)
• Use 17.0 mm wrench to loosen and remove
the orifice pack.
2-18
A B
C D
D. First groove (12.0 mm Natural
gas setting)
E. Venturi screw
C D
C. Adapter nut (17.0 mm)
D. Ori ce spud
E