Table of Contents
Advertisement
REMOVING THE SPARK MODULE & THE COOLING FAN
WARNING
Electrical Shock Hazard
Disconnect from electrical and gas supplies
before servicing unit.
Failure to do so could result in death, electri-
cal shock, or explosion.
CAUTION: When you work on the range, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1.
Turn off the gas supply and electrical
power to the range.
2.
Pull the range out from the cabinet far
enough to access the back panel.
3.
Remove the left side panel from the range
(see step 3 on page 4-14 for the proce-
dure).
Refer to Figure 4-12 for the following steps.
4.
To remove the spark module:
a) Disconnect the six wires from the ter-
minals of the spark module.
b) Remove the mounting screw from the
spark module and remove it from the
housing.
5.
To remove the cooling fan:
a) Remove the storage drawer from the
range and set it aside.
b) From inside the storage drawer area,
remove the screw from the front of the
housing.
c) From outside the range, remove the re-
maining screw from the front of the
housing, and lower the housing so you
can access the cooling fan mounting
screws.
d) Unplug the wires from the terminals of
the cooling fan.
e) Remove the three flat-head screws
from the cooling fan and remove the
fan from the housing.
4-16
Hide quick links:
Advertisement
Table of Contents
