Configuring The Printer's Netware Network Settings With Remoteui - Canon imagePROGRAF iPF6300S User Manual

4.
Specify the printer type.
1.
To use the printer in queue server mode, choose Other/Unknown in Type. To use remote printer mode, set
Printer Type to Parallel and Position to Manual Load.
2.
Press the Esc key.
3.
After the confirmation message is displayed, choose Yes and press the Enter key.
5.
Set a password.
1.
In Available Options, select Print Servers and press the Enter key.
2.
Select the print server created in step 2 and press the Enter key.
3.
Select Password, and press the Enter key to display the password input dialog box.
4.
Enter the password and press the Enter key.
6.
Press the Esc key several times to display the dialog box for confirming that PCONSOLE is finished.
7.
Click Yes to exit PCONSOLE.

Configuring the Printer's NetWare Network Settings With RemoteUI

Follow the steps below to configure NetWare protocol settings other than the frame type by using RemoteUI.
Note
• For details on RemoteUI, see "Using RemoteUI ."
1.
Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2.
Select Administrator Mode and click Logon.
3.
If a password has been set on the printer, enter the password.
4.
Click Network in the Device Manager menu at left to display the Network page.
5.
Click Edit in the upper-right corner of the NetWare group to display the Edit NetWare Protocol Settings page.
6.
Refer to the NetWare Settings Items table to complete the settings.
NetWare Settings Items
Item
Frame Type
NCP Burst Mode
iPF6300S
→P.938
Details
Specify the type of frame to use in NetWare.
Activate this setting to use NCP Burst Mode.
Configuring the Printer's NetWare Network Settings With RemoteUI
Network Setting > NetWare Settings
Default
Setting
Disabled
On
>
10
957