Quadra-Fire 5100I-GD-B Owner's Manual page 2

5100-i act wood insert advanced combustion technology (act)
Hide thumbs Also See for Quadra-Fire 5100I-GD-B:
Table of Contents

Advertisement

R
H
earth & Home Technologies welcomes you to our tradition
of excellence! In choosing a Quadra-Fire appliance, you have
our assurance of commitment to quality, durability, and perfor-
mance.
This commitment begins with our research of the market, includ-
ing 'Voice of the Customer' contacts, ensuring we make prod-
ucts that will satisfy your needs. Our Research and Development
facility then employs the world's most advanced technology to
Tested and
O-T L
Listed by
C
OMNI-Test Laboratories, Inc.
Report: 061-S-12-2
LISTED ROOM HEATER, SOLID FUEL TYPE. "For Use with Solid Wood Fuel
Only."Also for use in Mobile Home (UM) 84 HUD.
Install and use only in accordance with manufacturer's installation, venting
and operating instructions. CONTACT YOUR LOCAL BUILDING OR FIRE
OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION IN
YOUR AREA
Refer to manufacturer's instructions and local codes for precautions required
for passing chimney through a combustible wall or ceiling.
WARNING - For Mobile Homes: Do not install in a sleeping room. An
outside combustion air inlet must be provided and unrestricted while unit is
in use. The structural integrity of the mobile home floor, ceiling and walls
must be maintained. The insert must be properly grounded to the frame of
the mobile home. A complete relining of the chimney system with a 6"
diameter listed stainless liner is required. Must be equipped with a spark
arrestor cap. Outside Air comes standard on the insert and must be installed
before operating insert.
When used as a masonry insert stove, install only in a masonry fireplace
built to UBC Chapter 37. Do not remove brick or mortar to accommodate
insert. Installation requires minimum of a starter pipe into existing chimney
with airtight face seal.
Install only on a non-combustible hearth. Approved for installation and use
in factory built zero-clearance fireplaces conforming to minimum fire
chamber specifications (USA only).
Components required for installation: positive or direct flue connection
assembly or listed vent liner.
In Canada a full length 6" S635 flue liner is required as per ULC S628.
WARNING - Inspect and clean chimney frequently. Under certain conditions of
Maximum Mantel Depth - 8" (203mm)
Profondeur Maximum de la Manteau de Cheminée -
Mantel
A
F
Hearth Extension /
Non-combustible floor protector must be a minimum 1/2"
(13mm) thickness (k value = 0.84) and extend 8" (203mm) to
both sides.
La protection de plancher non-combustible doit être d'un minimum
de 1/2" d'paisseur (k value = 0.84) et étendue à 8" (203 mm) de
chaque côtés.
Manufactured by / Fabriqué par:
1445 N. Highway, Colville, WA 99114
www.quadrafire.com
Page 
and Welcome to the Quadra-Fire Family
SAMPLE OF SERIAL NUMBER / SAFETY LABEL
LOCATION: On right side of insert as face the appliance
CAUTION
:
HOT WHILE IN OPERATION DO NOT TOUCH, KEEP CHILDREN AND CLOTHING AWAY. CONTACT MAY CAUSE SKIN BURNS.
KEEP FURNISHINGS AND OTHER COMBUSTIBLE MATERIAL FAR AWAY FROM THE APPLIANCE. SEE NAMEPLATE AND INSTRUCTIONS.
:
ATTENTION
CHAUD LORS DE L' O PÉRATION. NE PAS TOUCHER. GARDEZ LES ENFANTS ET LES VÊTEMENTS LOIN DE L' E SPACE DÉSIGNÉ DE L' I NSTALLATION. LE CONTACT
PEUT CAUSER DES BRÛLURES À LA PEAU. GARDEZ LES MEUBLES ET LES MATÉRIAUX COMBUSTIBLES LOIN DE L' E SPACE DE L' A PPAREIL. VOIR L' É TIQUETTE ET LES INSTRUCTIONS.
Beaverton
Oregon USA
R
Tested to / Testé a:
UL 1482, ULC S628
APPAREIL DE CHAUFFAGE DE PIÈCE, DE TYPE DE COMBUSTIBLE SOLIDE, "Pour Usage
Avec Bois Solide Seulement" Pour usage dans les maisons mobiles (UM)84 HUD
PREVENT HOUSE FIRES
Installez et utilisez en accord avec les instructions d'installation et d'opération du
fabricant. CONTACTEZ LE BUREAU DE LA CONSTRUCTION OU LE BUREAU DES
INCENDIES AU SUJET DES RESTRICTIONS ET DES INSPECTIONS D'INSTALLATION
DANS VOTRE VOISINAGE.
Référez vous aux instructions du fabricant et des codes locaux pour les précautions
requises pour passer une cheminée à travers un mur ou un plafond combustibles, et
les compensations maximums.
AVIS - Pour Les Maisons Mobiles: Ne pas installer dans une chambre à coucher. Un
tuyau extérieur de combustion d'air doit être installé et ne doit pas être obstrué
lorsque l'appareil est en usage. La structure intégrale du plancher, du plafond et des
murs de la maison mobile doit être maintenue intacte. L'appareil de chauffage doit
être fixé à la charpente de la maison mobile. .
Lorsque vous utilisez un poêle inséré fabriqué en briques, installez un foyer en
briques fabriqué selon UBC Chapitre 37. Ne pas enlever de la brique ou du mortier
pour accommoder la pièce insérée. L'installation demande un tuyau allant de la
cheminée existante avec un couvert hermétique.
Installez seulement sur un foyer incombustible. Approuvé pour l'installation et
l'usage dans les cheminées avec espace libre de zéro, fabriquées en usine et se
ATTENTION!
conditions, il se peut que la créosote s'accumule rapidement.
Ne pas connecter cet appareil à une cheminée servant un autre appareil.
DANGER: Il y a risque de décharge électrique. Déconnectez le fil électrique de la prise de
contact avant le service.
Masonry, Heat Exchanger & *Zero Clearance
En briques, Circulant la chaleur & d'espace libre*
/
Manteau de Cheminée
with 5" (127mm) Mantel Deflector
B
/
avec un déflecteur de cheminée de 5" (127 mm)
Fascia or Trim
Panneau ou Moulure
with 8" (203mm) Mantel Deflector
avec un déflecteur de cheminée de 8" (203 mm)
*Zero Clearance Installations USA Only
C
*Installation avec espace libre de zéro seulement aux États-Unis
D
FLOOR PROTECTION /
Insert
PROTECTION DU PLANCHER
Pièce Insérée
USA/
E
CANADA
Extension de l'âtre
U.S. ENVIRONMENTAL PROTECTION AGENCY - Certified to comply with July 1990 particulate emission standards.
2004 2005 2006 Jan
Made in U.S.A. / Fait Aux États-Unis
5100-I ACT WOOD INSERT
achieve the optimum operation of our stoves, inserts and fire-
places. And yet we are old-fashioned when it comes to crafts-
manship. Each unit is meticulously fabricated and surfaces are
hand-finished for lasting beauty and enjoyment. Our pledge to
quality is completed as each model undergoes a quality control
inspection. We wish you and your family many years of enjoy-
ment in the warmth and comfort of your hearth appliance. Thank
you for choosing Quadra-Fire.
Model / Modèle:
Serial Number
5100-I ACT INSERT
007
PRÉVENTION DES FEUX DE MAISON
Inspectez et nettoyez la cheminée fréquemment. Sous certaines
A
B
12"/305mm
40"/1015mm
12"/305mm
31"/787mm
12"/305mm
27"/686mm
TRIM / Panneau
E
F
Side Trim
États-Unis
16"/406mm
Muir Panneau
8"/203mm
Top Trim
18"/457mm
8"/203mm
Haut Panneau
US Patents 4,766,876; 5,113,843; 5,341,794
Brevet US 4,766,876; 5,113,843; 5,341,794
Feb Mar
Apr May June July Aug Sept Oct. Nov. Dec.
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER L'ÉTIQUETTE
438-0380D
!
Serial Number
Model Name
Test Lab & Report No.
D
C
35"/889mm
7"/178mm
20"/508mm
7"/178mm
16"/406mm
7"/178mm
1-1/2" (38mm) thick
3/4" (19mm) thick
Manufactured Date
438-0390
September 1, 2008

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5100i-nl-b

Table of Contents