Speed Settings; Power Module - Pride Mobility Quantum Jazzy 1420 Owner's Manual

NOTE: If you still get "ripple up and down of lights," contact your Quantum Rehab Specialist.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, reminding you the
batteries need to be charged immediately!

Speed Settings

The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest speed setting is 5. The settings
are indicated by the number of lights that are lit.
NOTE: The speed settings are preset at the factory. If your Quantum Rehab Specialist changes the order of these
settings, please make note of these changes. Contact your Quantum Rehab Specialist for more information.
To select a speed setting:
1. Press the on/off key to power on the remote.
2. Press the mode key once.
3. To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase the speed setting.
4. To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the speed setting.
5. Once you select the desired speed setting, press the mode key once to keep the setting or push the joystick in the forward or reverse
direction. The chair will resume operation at the selected speed.
NOTE: We recommend that the first few times you operate your power chair, you have your speed on the
slowest setting until you become familiar with your new power chair.
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate them through
the remote keypad. Contact your Quantum Rehab Specialist for information on how to operate these accessories.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front of the controller. The
socket may also be used for reprogramming the controller by using a controller programmer, should this be necessary. If you use an off-
board charger, the charger current should not exceed 8 amps. Contact your Quantum Rehab Specialist for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket.
Controller Communications Cable
The controller communications cable provides the joystick module with a connection to the power module at the back of the power
base. See figure 26.

Power Module

Typically, the power module is mounted to the power base. The power module provides a power interface for the joystick module. It
routes the battery power to the motors and other powered accessories such as lights and power seats.
Actuator Lighting Module (Not Shown)
The actuator lighting module is also located on the power base. The actuator lighting module provides a control and power interface
between the power module, the lights, and/or the power seat actuator.
Quantum Jazzy 1420
V I I . O P E R A T I O N
www.quantumrehab.com 33