Replacing The Mouse - Lenovo 6423 Installation Manual

Replacing the mouse

This section provides instructions on how to replace a mouse.
1. Remove all media (diskettes, DVDs, or CDs,) from the drives, shut down your
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse. See Figure 30 and "Locating controls and
Figure 30. Replacing a mouse
4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse cable to one of the USB connectors.
6. Go to Chapter 4, "Completing the parts replacement," on page 43.
42
ThinkStation Hardware Installation and Replacement Guide
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide, go to the Support Web site at:
http://www.lenovo.com/support/
operating system, and turn off all attached devices and the computer.
connectors on the front of your computer" on page 5 or "Locating connectors
on the rear of your computer" on page 6.